Adding Tape Library and Tape Drives to the Enterprise
Last updated
Last updated
The following steps are required if you set up your tape library by using Manual Setup (Process B):
Add the tape library to your Enterprise. Use the Adding a Tape Library function in the management console. You need to supply information about the controller node. Follow the instructions in .
Assign the tape drives to the tape library.
To add the tape drives, use the Adding a Tape Library Device function in the management console. Follow the instructions in .
You need to supply information about the Device ID of the tape drive and the Device Number of the drive bay. See the following section for a discussion about Device ID and Device Number mappings.