Setting Restore Job Notification Options

Take the following steps to set the restore job notification options:

  1. Open the Set Job Notification Options dialog box from the Block Restore window. From the task panel, click Set Notification Options. The Set Job Notification Options dialog box appears.

  2. Complete the Set Job Notification Options dialog box as needed.

In the mail option, you can use the following options:

Mail Information

Two sets of mail information can be specified:

  • Output Email Specifies that the subsequent fields apply to reports that are sent when a job has completed.

  • Operator Email Specifies that the subsequent fields apply to mount requests, error messages, and informational messages that are sent during a job.

To

The email address of the primary recipient of your message. Only one “To” address is permitted.

Cc

Carbon Copy. The email address(es) of the secondary recipient(s) of your message. Use a semicolon to delimit multiple email addresses.

Bcc

Blind Carbon Copy. The email address of the secondary recipient not identified to other recipients. Use a semi-colon to delimit multiple email addresses.

Subject

The subject of your message. The subject line usually contains a combination of straight text and variable elements.

Variables, which must begin with %, are replaced with actual corresponding values. If you enclose variables in double quotation marks, those variables are treated as literal values. You can embed the following variables:

  • To

  • Cc

  • Bcc

  • Subject

  • %JOBNAME

  • %JOBID

  • %JOBTYPE

  • %RC

Use%RC to include the return code in the message for this run of the job, when applicable.

Restrictions. You cannot use > (greater than), < (less than), ; (semicolon), or ’ (single quote) in any fields.

No Notification

Selecting this check box option temporarily disables notifications for the job without deleting the currently defined job notification data. This option is not available for Catalog backup or Copy.

Note. The Catalogic DPX emailing must be enabled when you first configure your Enterprise. At that time, you supply general system information, including SMTP Host Name and SMTP Port. See Editing an Enterprise Configuration in the Reference Guide.

Last updated